Specifications

Alto 818 Installation and Operation
6-24 P/N 66109074001 Rev. D
6.3.14 OPEN
This command is applicable only if the Alto 818 system is set up to use building modes and open,
closed, and station sensors have been defined with the DOOR command (see Section 6.3.5).
Entering the OPEN command places the building in the building-open mode.
6.3.15 RELOCK
The RELOCK command reverses the UNLOCK command. This command applies only after the
UNLOCK command has been invoked. It relocks doors that were unlocked by the UNLOCK
command, and returns the door access status to its preconfigured parameters as set up in the
database.
YOUR COMMAND? RELOCK
DOOR (1-8 OR 0 FOR ALL)?
6.3.16 REPORT
The report command is evoked for each report that is to be assigned (up to 32 reports). Report
1 comes from the factory preprogrammed for a report which will be sent to the host at all times,
all days, including holidays. If you wish to keep the default settings for report 1, proceed to report
2, referring to the completed REPORT command database setup sheets for the parameters to
be entered for each report being defined. The default menu for the REPORT command is shown
in Figure 6-10.
To enter the reports in the database, proceed as follows:
1. From the command prompt, type REP and press Enter. The screen displays:
REPORT (1-32)?
2. Type the number of the report to be defined and press Enter. The screen displays:
GO TO (1-5)?