Specifications
Alto 818 Installation and Operation
6-36 P/N 66109074001 Rev. D
6.3.24 UNSHUNT
The UNSHUNT command is used to reverse the SHUNT command. The screen for the
UNSHUNT command is as follows:
YOUR COMMAND? UNSHUNT
(DOOR/MONITOR/COAX/SENSOR/MSM/TAMPER/POWER)/VIP/VIPTAMPER/READER/READERTAMPER)?
DOOR 1-8)?
6.3.25 USER
Throughout this manual, the word operator has been used to describe individuals who have
access to the system terminal in order to use the operate and program commands. However,
in the program commands, the word user is applied to individuals who have access to the system
commands, i.e., the operators and the system administrator.
This command is used to enter the name, password and rank of up to eight users. Because the
Alto 818 recognizes a user by the password entered, each password must be unique. Users
should know only their own password; the list of passwords for all users should be known only
to the system administrator and should be kept under lock and key. The user rank controls which
commands the user may execute; rank A has access to all commands. The prompts for this
command are shown in Figure 6-13. A USER setup sheet is included in Appendix B.
USER (1-8)? 1
1. NAME (12): ?
2. PASSWORD (12): NEW?
3. RANK (A-F): A?
Figure 6-13: USER Command Prompts
To define the system users, proceed as follows:
1. From the YOUR COMMAND? prompt, type US and press Enter. The screen displays:
USER (1-8)? 1
Accept the default 1 or type another user number, 28, and press Enter. The screen displays:
1. NAME (12) ?
2. Type a user name, up to 12 characters in length. Press Enter. The screen displays: