Specifications

Section 6: Commands

6-37

2. PASSWORD (12): NEW?

3. Type the password, up to 12 characters in length. Press Enter. The screen displays:

3. RANK (A-F) : A?

4. Type the rank for the user and press Enter. The command prompt is displayed.

6.3.26 VERSION

This command displays the firmware version of the Alto 818 in the format:

Please have this information available before seeking technical support from your dealer,

installer or WSE Customer Service.

6.3.27 XLOAD

The XLOAD command is used to load the system database into the Alto 818's memory from a

disk or diskette file created with the XSAVE command (Section 6.3.28). To load a database into

ACU memory from a backup diskette, proceed as follows:

1. Follow steps 1 and 2 in the XSAVE procedure. If the database was backed up to a diskette,

insert the diskette in the appropriate drive.

2. When the screen displays YOUR COMMAND?, type XLOAD and press ENTER.

3. On the PC, press Alt-M to access the menu. Select SEND A FILE and press ENTER.

4. Type the name of the source file and press ENTER.

5. Select XMODEM CHECKSUM and press ENTER.

The ACU will begin to receive data from the PC. Reset the ACU when the data transfer is

complete.