Specifications

Section 8: Operation
8-3
8.2 INITIAL POWER-ON
NOTE:
The initial power-on procedure should be performed by a technically-qualified operator.
Perform initial power-on as follows:
1. With the power switch in the OFF position, connect the power module to the AC source and
to the ACU as described in Section 4.1.
2. With the power switch in the OFF position, connect the terminal to ACU as described in
Section 4.7.
3. Loosen the six captive screws that attach the cover to the ACU and remove cover.
4. Locate the battery switch (S2) and turn switch to the ON position (see Figure 2-3); replace
the ACU cover.
5. Turn the power module ON. At the ACU, the vital function green LED should be blinking;
the terminal RX and TX green LEDs and the host TX green LED should be ON.
6. Turn the terminal ON; ignore the screen display and proceed to terminal setup in the following
section.