Specifications

Section 3: Installation Planning
3-15
Figure 3-2: S-Net Termination
3.6.8 WIRE INSERTION
For wire insertion to either fixed block or Phoenix connectors, the following procedure is
recommended:
1. Strip the wire end.
2. Twist the exposed strands tightly and tin the ends.
3. Crimp an appropriate size ferrule on the end of the wire. Be sure that the ferrule is crimped
on bare conductor metal, not the insulation.
Figure 3-3: Wire Insertion
4. Insert ferrule in the appropriate Phoenix connector terminal. Tighten the connector binding
screw and torque to 5 inch-pounds (0.56Nm).