UL_industrial_J 5/23/05 9:57 AM Page 1 UL-ES-I56/WJ-WH05 OWNER'S MANUAL MANUAL DEL USUARIO Industrial Please write model number here for future reference: / Por favor, incluya el número del modelo aquí para futura referencia: N.W. : 6.2 KGS G.W. : 7.
UL_industrial_J 5/23/05 9:57 AM Page 2 UL-ES-I56/WJ-WH05 SAFETY TIPS OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR PERSONAL INJURY, MOUNT TO OUTLET BOX MARKED "ACCEPTABLE FOR FAN SUPPORT", AND USE THE OUTLET SCREWS PROVIDED WITH THE OUTLET BOX. MOST OUTLET BOXES COMMONLY USED FOR THE SUPPORT OF LIGHTING FIXTURES ARE NOT ACCEPTABLE FOR FAN SUPPORT AND MAY NEED TO BE REPLACED. CONSULT A QUALIFIED ELECTRICIAN IF IN DOUBT. 1.
UL_industrial_J 5/23/05 9:57 AM Page 3 UL-ES-I56/WJ-WH05 CONSEJOS DE SEGURIDAD HAGA LO SIGUIENTE: LEA Y GUARDE ESTAS INSTRUCCIONES ADVERTENCIA: PARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA ELÉCTRICA O LESIONES PERSONALES, MONTE EL VENTILADOR EN UNA CAJA DE EMBUTIR ROTULADA “ADECUADA PARA VENTILADORES”, Y UTILICE LOS TORNILLOS DE MONTAJE INCLUIDOS CON LA CAJA DE EMBUTIR.
UL_industrial_J 5/23/05 9:57 AM Page 4 UL-ES-I56/WJ-WH05 PREPARING FOR INSTALLATION ANTES DE LA INSTALACIÓN 1 2 Unpack and inspect fan carefully to be certain all contents are included. Turn off power at fuse box to avoid possible electrical shock. Use metal outlet box suitable for fan support (must support 35 lbs). Before attaching fan to outlet box, ensure the outlet box is securely fastened by at least two points to a structural ceiling member (a loose box will cause the fan to wobble).
UL_industrial_J 5/23/05 9:57 AM Page 5 UL-ES-I56/WJ-WH05 MOUNTING BRACKET INSTALLATION INSTALACIÓN CON SOPORTE DE MONTAJE 4 3 Install “J” hook mounting plate to outlet box in ceiling using the screws provided with the outlet box. Instale la placa de montaje del gancho “J” a la caja de embutir del cielorraso con la tornillería suministrada para la caja de embutir. Loosen set screws on both upper and lower canopies. Install canopies onto downrod as shown. Thread lead wires through the downrod.
UL_industrial_J 5/23/05 9:57 AM Page 6 UL-ES-I56/WJ-WH05 5 3 4 63 1 5 2 Thread leadwires through the downrod and install crosspin (1) through yoke (2) and downrod. Install lockwasher (3) and nut (4) and tighten. Install cotter pin (5). Loosen set screw in lower canopy and slide to within 1/4” of the motor. Tighten set screw(s) in the lower canopy. Make sure there is at least 1/4” clearance maintained around the motor and lower canopy.
UL_industrial_J 5/23/05 9:57 AM Page 7 UL-ES-I56/WJ-WH05 7 8 WALL CONTROL WIRING OPTION Follow diagram above to make wiring connections for wall control operation. Note: A professional electrician is recommended for this type of installation. OPCIÓN DE CABLEADO PARA CONTROL DE PARED Hang fan on “J” hook. With bracket holding fan assembly, make electrical connections using the following step for wiring instructions.
UL_industrial_J 5/23/05 9:57 AM Page 8 UL-ES-I56/WJ-WH05 93 10 3 After wiring is complete, gently push wires into junction box with wire nuts pointed upward. Slide top canopy up and tighten set screw(s). Una vez que el cableado esté completo, empuje con cuidado los cables dentro de la caja de empalmes con los conectores de tuerca mirando hacia arriba. Deslice el dosel superior y ajuste el(los) tornillo(s) de fijación.
UL_industrial_J 5/23/05 9:57 AM Page 9 UL-ES-I56/WJ-WH05 11 3 Install blades to top of motor using screws and washers . See above drawing for reference. Instale las paletas en la parte superior del motor con la tornillería. Utilice la ilustración anterior como referencia.
UL_industrial_J 5/23/05 9:57 AM Page 10 UL-ES-I56/WJ-WH05 INSTALLING AND WIRING THE WALL CONTROL INSTALACIÓN Y CABLEADO DEL CONTROL DE PARED 12 Instalación y cableado del control de pared. Parts: 1. Outlet box 2. Cross Bar Screws 3. Cross Bar 4. Outlet Box Screws 5. Control Unit 6. Terminal Box 7. Front Panel 8. Front Panel Screw 9. Terminal Box Screw 10. Black Supply Lead Wire 11. Black Fan Lead Wire 12. Ground Lead Wire A.
UL_industrial_J 5/23/05 9:57 AM Page 11 UL-ES-I56/WJ-WH05 INSTALLING AND WIRING THE WALL CONTROL INSTALACIÓN Y CABLEADO DEL CONTROL DE PARED 1 2 3 12 4 5 7 8 11 10 6 9 11
UL_industrial_J 5/23/05 9:57 AM Page 12 UL-ES-I56/WJ-WH05 TROUBLESHOOTING GUIDE If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, please consult with your authorized electrician and do not attempt any electrical repairs yourself.
UL_industrial_J 5/23/05 9:57 AM Page 13 UL-ES-I56/WJ-WH05 GUÍA PARA SOLUCIONAR PROBLEMAS Si tiene dificultades para hacer funcionar su nuevo ventilador, podría ser a causa del armado, instalación o cableado incorrectos. En algunos casos, estos errores de instalación podrían ser confundidos con defectos. Si experimenta alguna falla, consulte esta guía para solucionar problemas. Si no puede solucionar el problema, consulte a un electricista autorizado y no intente reparar conexiones eléctricas.
UL_industrial_J 5/23/05 9:57 AM Page 14 UL-ES-I56/WJ-WH05 14
UL_industrial_J 5/23/05 9:57 AM Page 15 UL-ES-I56/WJ-WH05 PARTS LIST LISTA DE REPUESTOS 1 # 1 2 3 8 Description . . . . . . . . . . . . . . . . . Mounting Bracket . . . . . . . . . . . . . . . . . Blade . . . . . . . . . . . . . . . . . Wall Control . . . . . . . . . . . . . . . . . Hardware Pack No. 1 2 3 8 2 Descripción . . . . . . . . . . . . . . . . .Soporte de montaje . . . . . . . . . . . . . . . . .Paleta . . . . . . . . . . . . . . . . .Control de pared . . . . . . . . . . . . . . . . .
UL_industrial_J 5/23/05 9:57 AM Page 16 UL-ES-I56/WJ-WH05 Westinghouse Lighting Corporation 12401 McNulty Road Philadelphia, PA 19154 U.S.A. Westinghouse Lighting Corporation 12401 McNulty Road Philadelphia, PA 19154 U.S.A.