User manual

INSTALLATION
If oor is not level, adjust
levelling legs to suit
POWE R S UPPL Y
230/240V
-10Am
p
s
The hos e s hould not be
extended by more than
2 metres or water pump-
out
problems ma y occu r
Fix drain hose max of
10mm below the top of
the dishwashe r
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
• K ickplate xing screws •
Gap on both sides should be
equal, & no greater than
5mm per side.
600mm max.
300mm min.
Secure dishwasher with
brackets and screws provided
Inlet water supply
• Cold water pressure: 800 kPa max -
50 kPa min
• Water flow rate 10 L/minute min.
• If cold water pressure is in excess of
800 kPa, a pressure-reducing valve
should be used. Check for leaks.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Install the appliance under a counter (kitch-
en worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and drain.
For the venting of the appliance only water
hoses and mains cable openings are nec-
essary.
The appliance has adjustable feet to allow
the adjustment of its height.
Make sure that the water inlet hose, the
drain hose and the mains cable are not
kinked or squashed, when you insert the
appliance.
Make sure that the dimensions of the re-
cess agree with the given dimensions.
Adjusting the height of the appliance
Follow these steps to adjust the height of
the appliance
1. Loosen or tighten the two front feet.
16 westinghouse