User manual

2. Loosen and remove the adjustable
plinth.
3. Adjust the rear foot. Turn the screw in
the middle of the front kick-plate to the
left or to the right.
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. Loos-
en or tighten the adjustable feet until the
appliance is level.
Adjusting the height of the plinth
If there is a space between the floor and the
bottom of the appliance, you can lower the
plinth to cover it.
Adhesive steam protection foil
Fit the steam protection on the front part of
the worktop along the entire width.
600 mm
Fixing to the adjacent units
Warning! Use the supplied brackets to
attach the appliance under the worktop
or to the adjacent units, to prevent
injury or damage.
1. Fit the supplied angular brackets in the
slots on the top of the appliance.
2. Use the supplied screws to secure the
appliance in position (upwards or side-
ways). Make sure the screws are tight-
ened.
Custom made kick-panel
For integrated appliances and full-stainless-
steel door appliances.
We recommend that you make a custom
made kick-panel that aligns your kitchen
cabinets.
• A notched continuous panel is necessary
to prevent door swing interference and to
keep kick-panel alignment with adjacent
units.
westinghouse 17