Use and Care Manual

0605
Control Panel:
Installation Procedures:
Disconnect the power supply, hold the two
buckles at the bottom of the Front Cover, to
take off the Front Cover.
Illustration Diagram:
NCCO Reactor
Basic Information
Main Parts & Components
Install NCCO Reactor, HEPA Filter and Pre-filter in sequence into HEPA Filter Frame. A clicking sound
should be heard to indicate that successful of filters installation.
Remove all packaging materials before usage.
*Unit supports 2.4Ghz / 5Ghz Wifi. If there is any connection problem, please contact your router
supplier for problem solution.
Display Screen
Air Speed
Reduce Button
Air Speed
Increase Button
Eco Mode
Button
ON / OFF
Button
Control Panel
A
B
C
D
E
F
G
H
Front Cover
Pre-filter
HEPA Filter Frame
Back Cover
Air Outlet
1. Remove all packaging materials, use a soft dry
cloth to clean all the parts then re-assemble
parts back together.
2. Place the unit on a dry, solid, level surface,
and ensure the unit is provided with reasonable
space of at least 15 cm from any objects, in
order to operate effectively.
3. Check power sockets and any extension cords
to confirm compliance with unit requirements.
Ensure that the unit is plugged in before usage.
4. The unit is equipped with a sensor. If filters are
not installed properly, the unit will not operate.
5. When the unit is turned on for the first time,
warm air and mineral smell may be released
from the air outlet. This is normal as catalytic
oxidation is taking place inside the NCCO Reactor,
and completely harmless to human body.
Getting Started
First-time Operation
Power Cord Inlet
Power Cord
I
J
HEPA Filter