Installation Guide

8 electrolux.com.au
ATTACHING THE REAR ROLLERS
A set of adjustable back feet/rollers is provided in the kit.
These are required to ensure that the product is levelled
correctly, failure to fit these may result in the poor operation
of door opening.
1. Temporarily unfasten the screws holding the
evaporator tray.
2. Fit the right assembly.
3. Repeat for the left hand side.
Once fitted turn the adjusting nut on each roller assembly
anti-clockwise three full turns, this will raise the cabinet
at the rear by approximately 12mm (ensure that the nut is
completely wound up before turning).
Then secure the nut and roller assembly in place with tape
(this will prevent the roller assembly from falling out when
the refrigerator is place in the cupboard).
INSTALLATION (CONTINUED)