Full Product Manual

Westinghouse Portable Power | 17
MANUALLY STARTING THE GENERATOR
1. Check oil levels (see Adding Engine Oil page 20)
2. Make sure the circuit breakers are properly set (see
Figure 7 below).
240/120VMain Circuit Breaker Operating Position
240/120V Main Circuit Breaker Tripped Position
120V Circuit Breaker Operating Position
120V Circuit Breaker Tripped Position
3. Move the fuel shut o valve to the ON position (see
Figure 8 below).
ON
OFF
Figure 8 - Fuel Shut O - ON
4. Move the choke lever to the “ON” position (see
Figure 9 below).
Figure 9 - Choke Lever - ON
5. Push the engine control switch into the RUN
position (see Figure 10 below).
6. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance. At this point, apply
a rapid pull while pulling up and slightly away from
the generator (see Figure 11).
7. As the engine starts and stabilizes, gradually move
the choke lever back to the OFF position (see
Figure 12 below).
OPERATION
Figure 7 - Breakers
Figure 10 - Engine Control Switch - RUN
Figure 11 - Engine Recoil Handle - PULL
Figure 12 - Choke Lever - OFF
1
2
3
4