Full Product Manual

OPERATION

2. Start one of the inverters and wait until the ready

light is on.

3. Turn both cord switches to ON (I).

4. Start the remaining inverter; wait until the ready

light is on before connecting the load.

5. When power is present, a light will illuminate in the

three-prong plug that is plugged into the inverter.

Figure 15 – Paralleling Cord Connected

6. To stop the inverters, unplug all connected loads,

turn both cord switches to OFF (O) and unplug the

cord on each inverter.

7. If during operation the inverters’ output is stopped

due to overloading, reduce the connected load by

unplugging appliances, and then push the reset

button and restart the inverter. When the ready light

is on, the load can be reconnected.

INITIAL OIL FILL

NOTICE

Engine oil must be added when the inverter is on

a ﬂat, level surface, or an inaccurate reading may

result. Do not overﬁll. If the engine is overﬁlled with

oil, it can cause serious engine damage.

1. Loosen the screw and remove the engine oil ﬁll/

drain plug service panel to access the oil ﬁll/drain

plug (see Figure 21).

Figure 21 – Engine Service Panel

2. Clean the area around the oil ﬁll/drain plug and

remove plug (see Figure 22).

NOTE:

Figure 22 – Oil Fill/Drain Plug

The oil capacity for the 2200iXLT is

400 ml.