Use and Care Manual

15
ASSEMBLY
4. Install the mounting feet to the frame using four
M6 x 18 mm bolts and M6 locking flange nuts (see
Figure 7).
1
1
3
2
2
Figure 7 – Assemble Mounting Feet to Frame
1 - Mounting Feet
2 - M6 x 18 mm
Bolts
3 - M6 Locking
Flange Nuts
5. Install the M12 x 105 mm wheel axle flange bolt
through the wheel (see Figure 8).
6. Thread the M12 serrated flange nut onto the bolt
with serrated edges facing away from the wheel.
Tighten the nut (see Figure 8).
1
2
Figure 8 – Installing Outside Serrated Flange Nut
1 - Wheel Axle
Flange Bolt
2 - Serrated Flange
Nut
7. Install the wheel with bolt through the axle bracket
on the frame (see Figure 9).
8. Install the serrated flange nut and tighten (see
Figure 9).
1
2
Figure 9 – Assemble Wheels to Frame
1 - Axle Bracket 2 - Serrated Flange
Nut
9. Install the handles using the clevis pin and hairpin
cotter. Install the nylon washers on the outside and
inside of the handle as shown in Figure 10.
2
4
1
3
Figure 10 – Attaching the Handles
1 - Clevis Pin
2 - Handle
3 - Nylon Washers
4 - Hairpin Cotter