GAS COOKTOPS User and Installation Manual MODELS CHG642SB/WB, CHG646SB/WB, CHG606SB, CHG956SB/WB, SHG646SB, SHG956SB, ZHG645SA,ZHG955SA WHG640SB/WB, WHG640SC/WC, WHG643SA/SB, WHG645SA/WA, WHG645SB/WB,WHG951SB, WHG953SB,WHG955SA/WA,WHG955SB/WB
CONGRATULATIONS Congratulations and thank you for choosing our Gas Cooktop. We are sure you will find your new appliance a pleasure to use and a great asset to your cooking. Before you use the appliance, we recommend that you read through the whole user manual which provides a description of the product and its functions.
general safety Read the following carefully to avoid an electric shock or fire General warnings • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Young children should be supervised to ensure they do not play with this appliance.
using your cooktop warning DO NOT spray aerosols in the vicinity of this appliance while it is in operation as aerosols can contain flammable propellants. warning Where the appliance is installed in any confined area, the area must be properly ventilated. It MUST NOT be used as a space heater. Controls Each burner is controlled by a control knob. The markings on the control panel indicate which burner the knob controls, and the settings for that burner (see Figure 2).
cleaning and care warning Ensure the appliance is off and cool before cleaning. Enamel Persistent stains may require rubbing with a nylon scourer or creamed powder cleansers. Household enamel cleaners are available, follow the manufacturer’s instructions in their use. Harsh abrasive cleaners, powder cleaners, steel wool or wax polishes should not be used. Stainless steel NOTE: Ensure any oil is cleaned off the hob before use, otherwise it may cause the hob to turn a yellowish colour.
troubleshooting If you have a problem with the cooktop, check the table below. You may be able to solve the problem and this will save you from paying for a service call. You will have to pay for a service call even in the warranty period if the problem is one listed below.
technical data FEATURES CHG642SB/WB CHG646SB/WB CHG956SB/WB CHG606SB Chef Chef Chef Chef 4 4 5 4 Yes Yes Yes Yes Ignition 1.
technical data FEATURES SHG646SB SHG956SB ZHG645SA ZHG955SA Simpson Simpson Zanussi Zanussi 4 5 4 5 Yes Yes Yes Yes Ignition 220-240V 220-240V 220-240V 220-240V Trivet Wire Matt Wire Matt Cast Iron Cast Iron Stainless Steel Stainless Steel Stainless Steel Stainless Steel Ignition through knob Ignition through knob Ignition through knob Ignition through knob Yes Yes Yes Yes NG, (LP conversion kit supplied) NG, (LP conversion kit supplied) NG, (LP conversion kit suppli
technical data WHG640SB/WB WHG643SA WHG645SA/WA WHG951SB WHG955SA/WA Westinghouse Westinghouse Westinghouse Westinghouse Westinghouse 4 4 4 5 5 No Yes Yes Yes Yes 220-240V 220-240V 220-240V 220-240V 220-240V Wire Matt Wire Matt Cast Iron Wire Matt Cast Iron Stainless Steel/ Enamelled White Stainless Steel Stainless Steel/ Enamelled White Stainless Steel/ Enamelled White Stainless Steel Ignition through knob Ignition through knob Ignition through knob Ignition through kn
technical data WHG640SC/WC WHG643SB WHG645SB/WB WHG953SB WHG955SB/WB Westinghouse Westinghouse Westinghouse Westinghouse Westinghouse 4 4 4 5 5 No Yes Yes Yes Yes 220-240V 220-240V 220-240V 220-240V 220-240V Wire Matt Wire Matt Cast Iron Wire Matt Cast Iron Stainless Steel/ Enamelled White Stainless Steel Stainless Steel/ Enamelled White Stainless Steel Stainless Steel/ Enamelled White Ignition through knob Ignition through knob Ignition through knob Ignition through kn
installation Table 2 Cooktop dimensions width (mm) Square 600 NOTE: For installation into a standard 600mm width benchtop the clearance specified can not be achieved Rectangular and combustible surfaces must be protected in 860 accordance with the above clauses. 3. Optional barrier: A barrier can be installed to prevent accidental contact with the cooktop base, where the base of height (mm) 55 51 the cooktop is accessible from below (i.e. Inside a cupboard, Cut-out dimensions etc.).
installation Figure 5 Operation on NG/SNG 110mm wall Regulator An appliance regulator is provided. The regulator must be positioned so that the pressure test nipple is accessible when the appliance is installed. Connect the gas supply to the ½ ” B.S.P. internal thread inlet of the regulator. Refer to ‘bench cutout’ (Figure 4) for connection point position. Regulators are supplied pre-adjusted and configured by the component maker for use with Natural Gas.
installation Checking the gas supply 1. Check the manometer zero point is correct. 2. Connect the manometer to the cooktop pressure point. This is located on the regulator. 3. Turn on the gas supply and electricity and try to ignite the gas. tips & information It will take additional time to light the gas for the first time as air needs to be purged from the pipes. 4.
LPG conversion This appliance is supplied set up for Natural Gas usage. A conversion kit is included with the product for Universal LPG usage. The conversion kit contains the appropriate injectors and 1 LPG sticker. Please follow the procedure below if a conversion to suit UNIVERSAL LPG is required: 1. Remove the hotplate trivets, burner caps and burner crowns to access the hotplate injectors. Replace the factory fitted injectors with the appropriate injectors, as supplied.
electrical connection Battery connection Battery holder installation instructions The battery used is a 1.5 Volt ‘AA’ Battery. This supplies the power for the ignition system of the cooktop. To install, follow the safety instructions as shown on Figure 8 below. 1. Locate a convenient position to mount battery holder, keeping it away from hot surfaces. NOTE: Pay special attention to the orientation of the battery when installing. The battery supplied is a perishable item and not covered by the warranty.
testing appliance operation After installation, test the appliance and ensure that it operates correctly before handing it over to the customer. The following procedure is recommended: Injector sizes required for various gas types are shown in Table 3 (page 14). The appliance inlet pressure for each gas type is also shown. 1. Turn on the gas and electricity supply and attempt ignition on all burners, both separately and in combination. (For correct procedure, refer to page 4).
notes Gas Cooktops NOTES 17
notes 18 NOTES Gas Cooktops
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: BUILT-IN OVENS, COOKTOPS AND FREESTANDING COOKERS This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance. This warranty is in addition to other rights you may have under the Australian Consumer Law.
like to know more? For further information on all appliances, or to obtain detailed dimension and installation information, call into your Retailer, phone or email our Customer Care team or visit our website: Australia phone: .................................................. 13 13 49 email: ............................. customercare@electrolux.com.au website ..................................... chef.com.au (Chef models) ........................westinghouse.com.
