User manual

5INSTALLATION

INSTALLATION INSTRUCTIONS

Built-in appliances

• Only use the built-in appliances after you assemble

the appliance into correct built-in units and work

surfaces that align to the standards.

Connection cable

• Use the correct mains cable of type H05BB-F Tmax

90°C (or higher) for a single phase or two

phase connection.

• Replace the damaged mains cable with a special

cable (type H05BB-F Tmax 90°C or higher). Speak to

your local Service Centre.

To attach the seal

• Clean the worktop in the area of the cut out section.

• Bond the seal stripe supplied on the lower edge

of the appliance along the outer edge of the glass

ceramic. Do not extend it. Let stay the cut ends in the

middle of one side. When, you cut it to length (add

some mm), push the two ends together.

Assembly

min.

500mm

min. 50mm min. 50mm

min.

5mm

Make sure a ventilation space of 5mm directly below the

benchtop is included in the installation and is kept free.

The warranty does not cover functional failures caused by

the lack of adequate ventilation

WARNING

Refer to “Safety information” chapter.

TIPS & INFORMATION

IMPORTANT

Before the installation, note down the serial number (Ser.

Nr.) from the rating plate at the front of this manual. The

rating plate of the appliance is on its lower casing.