USER MANUAL REFRIGERATION Bar Fridges with Ice Box, All Refrigerators and Upright Freezers WIM1000WC, WIM1200WD, WIM1200AE, WRM1400WD, WRM2400WE, WFM0900WD, WFM1700WE
CONGRATULATIONS CONTENTS Dear customer, Important safety instructions.....................................................3 Bar refrigerator with ice box features ....................................4 Bar refrigerator without ice box features .............................5 Single door all refrigerator features .......................................6 Bar freezer features ......................................................................7 Single door all freezer features ..............................
BAR REFRIGERATORS WITH ICE BOX FEATURES BAR REFRIGERATORS WITHOUT ICE BOX FEATURES 1 4 11 5 9 12 2 8 9 3 3 4 2 7 1 6 10 7 13 8 10 15 5 6 WIM1000WC illustrated 11 WRM1400WD illustrated 13 4 12 1 Control knob 9 Door seal 3 2 Light 10 Drain hole 2 3 Light Switch 11 1 4 Glass shelf 5 Glass Crisper Cover 6 Crisper 7 Door bin 8 Egg tray 11 10 6 14 7 8 Adjustable levelling leg Features may vary depending on model. Not all models will have features listed.
SINGLE DOOR ALL REFRIGERATOR FEATURES BAR FREEZER FEATURES 3 1 1 3 2 7 2 4 WFM0900WD illustrated 8 4 9 5 1 Temperature control 2 Freezer bin 3 Door seal 4 Adjustable levelling leg 6 WRM2400WE illustrated 1 Controller box and LED light 8 Lower door shelf 2 Refrigerator shelf 9 Refrigerator door 3 Egg tray 4 Vegetable drawer cover 5 Vegetable drawer 6 Adjustable bottom feet 7 Upper door shelf Features may vary depending on model.
INSTALLING YOUR NEW APPLIANCE SINGLE DOOR ALL FREEZER FEATURES 1 2 Adequate ventilation around your refrigerator. 1. Before you move your appliance into the place where it will operate, check that it will have adequate clearance. Clearance is required for air circulation and too little clearance may affect the performance of your appliance. 2.
ICE BOX MODELS (WIM1000 & WIM1200) INITIAL START-UP – FRIDGES Refrigerator models WRM1400 & WRM2400 have been fitted with a 'wet wall' evaporator which is positioned behind the rear liner. The rear liner will, at times be wet or appear frosted. This is normal and demonstrates that the refrigerator is functioning correctly. This product is designed to operate on a power supply of 220/240 volts 50Hz. Connect to a separate power point with a correctly earthed three pin socket. Do not use double adaptors.
INITIAL START-UP – FREEZER (WFM0900) Your freezer was cleaned and polished before it left the factory. Before use, dust and wipe over inside and out using a clean dry cloth. This product is designed to operate on a power supply of 220/240 volts 50Hz. Connect to a separate power point with a correctly earthed three pin socket. Do not use double adaptors.
CHANGING OVER THE ICE BOX DOOR (WIM1200 ONLY) REVERSING THE DOOR OPENING DIRECTION (WRM2400 & WFM1700) 1. Keep the freezer compartment door closed. Using a screwdriver, remove the mount screw for the installation button, and take the installation button down. The side at which the door opens can be changed, from the right side (as supplied) to the left side, if the installation site requires. WARNING WARNING 4. Remove the door from the lower hinge.
REVERSING THE DOOR OPENING DIRECTION (WRM2400 & WFM1800) REVERSING THE DOOR OPENING DIRECTION (WIM1000) 7. Replace the lower hinge part to the right side and fixing it which the special flange self-tapping screws. Replace the adjustable bottom feet part to another side and fixing it. In these examples the operation is changed from right side hinging to left side hinging. 8. Transfer the door to the properly position, adjust the lower hinge part, make the hinge axis into the lower hole of the door.
REVERSING THE DOOR OPENING DIRECTION (WFM0900, WIM1200 & WRM1400) The side in which the door opens can be changed from the right side (as supplied) to the left side, if the installation site allows for it. Tools you will need: 1. 8mm socket driver 2. Phillips head screwdriver 3. . 3. Lift the door and place it .on a padded surface to prevent scratching. Remove both adjustable feet and remove the bottom hinge ..bracket by unscrewing the bolts. Then transfer them to the other side. Note: 1.
GENERAL INFORMATION Cleaning the refrigerator WARNING WARNING WHAT TO DO BEFORE CALLING FOR SERVICE PROBLEM SOLUTION Refrigerator is not operating Check that the power cord is plugged into the power outlet properly and that the outlet is switched ‘ON’. BEFORE CLEANING: Turn the refrigerator off at the power point and unplug the cord to prevent any chance of electrocuting yourself. ry running another appliance from the power outlet.
Warranty TROUBLESHOOTING FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: WESTINGHOUSE REFRIGERATORS AND FREEZERS •A re doors kept open too long or too often? This document sets out the terms and conditions of the product warranties for Westinghouse Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance.
For more information on all Westinghouse appliances, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 13 13 49 email: customercare@electrolux.com.au web: westinghouse.com.au NEW ZEALAND phone: 0800 436 245 email: customercare@electrolux.co.nz web: westinghouse.co.nz and WESTINGHOUSE are trademarks of Westinghouse Electric Corporation. Used under license by Electrolux Home Products Pty Ltd.