Full Product Manual

18 | English
CARE AND MAINTENANCE
Maintenance parts can be purchased directly from the factory. A partial list of maintenance parts is below. For a
complete list of maintenance parts or for additional information email us at [e-mail] or
call 1-855-944-3571.
Inlet Filter ..............................................................................................................................................04000267-0
Turbo Nozzle ........................................................................................................................................02000313-0
Soap Nozzle .........................................................................................................................................04000388-0
0˚ Nozzle ..............................................................................................................................................03000310-0
15˚ Nozzle ............................................................................................................................................03000321-0
25˚ Nozzle ............................................................................................................................................03000309-0
WARNING
Do not use attachments or accessories that are not recommended for use with this
product. Making unauthorized modications and using incompatible accessories can damage the unit and
void your warranty.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTION
Unit will not turn on.
Pressure washer is not connected to a power
source or the power source isn’t grounded
Connect the power cord to a grounded
120Volt outlet
Water pressure is in the hose Pull the trigger to release the water
pressure.
GFCI is tripped Press the RESET button on the power cord
Defective motor or power cord. Contact Westinghouse customer service
toll-free at 1 [phone].
The unit is running but
there is no water ow.
Improper water source Connect the pressure washer to a water
main. Do not use this device with water from
a lake, pool, pond, etc.
Clogged nozzle Clean the nozzle
Defective spray lance Replace the lance
Water is leaking where
the hose connects to
the spray gun.
Defective or missing O-ring between the high
pressure hose and the spray gun.
Replace the o-ring.
The pressure washer
turns on for 2 seconds,
shuts off, and will not
turn back on.
The auto-start feature is turning the unit off. When the pressure washer is turned on, the
motor may run for 1 - 2 seconds to prime
the pump. Then it will automatically shut
off until the spray gun trigger is squeezed.
This is normal and does not indicate a
problem.