Full Product Manual

Westinghouse Outdoor Power Equipment, LLC | 11
ASSEMBLY
CONNECT THE GARDEN HOSE
NOTICE
Never connect your pressure washer to a hot water
supply. Connecting your pressure washer to a hot water
source will signicantly reduce the life of the pump and
will void the warranty.
The water supply must come from a pressurized water
spigot. NEVER use hot water or water from pools, lakes,
etc. Before connecting the garden hose to the pressure
washer:
1. Run water through the hose for 30 seconds to clean any
debris from the hose.
2. Inspect the screen and gasket in the pump water inlet.
If the screen or gasket is damaged, do not use the
pressure washer until replaced.
3. If the screen is dirty, clean it before connecting the
garden hose to the pump.
4. Completely uncoil the garden hose or remove completely
from reel to prevent kinks.
NOTICE
There must be a minimum of 10 ft. (3 m) of unrestricted
hose between the pressure washer intake and the hose
faucet or shut off valve (such as a “Y” shut off connector).
5. With the hose faucet turned completely off, attach the
end of the garden hose to the pump water inlet. Tighten
by hand.
NOTICE
Do not run the pressure washer without the water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure the
hose is not being restricted by tires, rocks, or any other
objects that may lessen or prevent water ow to the
pressure washer