User Manual

7
4. Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level. You can
adjust the level with the rollers as detailed in step 3.
aligned to cupboards
ie. even gap
Adjust front rollers
for uneveness of floor
eg. wind this roller
down or up
top of refrigerator is
level ie. horizontal
5. If you find your refrigerator rocks from corner to
corner, it means your floor is uneven. Find a piece
of plastic or hardboard etc. and pack it firmly under
the roller.
6. On certain floor surfaces the refrigerator may roll
forward during operation. Where provided a “Roller
Stop” can be placed under the front rollers. If Roller
Stop is required, contact customer service on
1300 363 640.
roller stop
7. You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5.
8. When you have the appliance in its final position, it
needs to be stablisied. Wind the stability foot down
to the floor until it just makes contact with the floor.
Lift the front of the appliance to take the weight off
the stability foot, then turn it ¼ turn further to ensure
firm contact with the floor. Whenever you need to
move the appliance, be sure to wind the foot back
up so that the appliance can roll freely and be sure to
reset it when reinstalling.
Stabilising foot
wound down
side view
front view
9. Clean your refrigerator thoroughly following the
instructions on page 16 and wipe off any dust that
has accumulated during shipping.
10. Plug your refrigerator straight into its own
powerpoint and never use a double adapter. If
you need to roll the refrigerator to get to the plug,
remember to raise the stability foot first.
11. Before you put any food in your refrigerator, it’s
recommended you leave it on for 2 or 3 hours to
check it is running properly.
Congratulations! You have successfully installed your new
refrigerator.
INSTALLING YOUR REFRIGERATOR
INSTALLATION