INSTALLATION AND USER MANUAL WRG970CS WRG980CGS CANOPY RANGEHOODS
contents congratulations contents Congratulations and thank you for choosing our canopy rangehood. We are sure you will find your new rangehood a pleasure to use. Before you use your rangehood, we recommend that you read through the whole user manual, which provides the description of the rangehood and its function. Product description . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important safety instructions . . . . . . . . . . . . . . . . . . . .
PRODUCT DESCRIPTION WRG980CGS WRG970CS 1 2 3 4 5 6 7 Component list Technical Specifications 1. 2. 3. 4. 5. 6. 7. 8. Model: Power supply: Motor: Lights: WRG970CS 220 – 240 volts 50Hz. input power 200 watts 2 x 20 watt 12 volt halogen Model: Power supply: Motor: Lights: WRG980CGS 220 – 240 volts 50Hz.
safety SAFETY Electrical Connection This manual explains the proper use of your new canopy rangehood. Please read this manual carefully before using the product. This manual should be kept in a safe place for handy reference. This canopy rangehood is a domestic appliance which has been manufactured and tested to comply with Australian and New Zealand Standard AS/NZS 60335.2.31. • Check that the mains voltage matches with the voltage on the data plate inside the canopy rangehood.
INSTALLATION Electrical Connection Check that the installation complies with standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood.
INSTALLATION installation sequence Fig. A Fig. B 1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line at the hood base position (refer diagram above). NOTE: The height of the underside of the hood body must be a minimum of 600mm above an electric cooktop & 650mm above a gas cook top and a maximum height of 800mm (refer to table below).
USING THE RANGEHOOD Care must be taken to ensure the screws are not cross threaded when attaching the outer flue cover. If installed in recirculating mode, insert the optional carbon filter included in recirculation kit AR600RK for model WRG970CS and AR600RKG for model WRG980CGS. To complete the rangehood installation, insert the three filters to the underside of the hood body. Place back edge of filter into position and push up front edge so that the filter clips into place.
HALOGEN LAMPS MAINTENANCE AND CLEANING Changing the halogen lamps • Before maintenance or cleaning is carried out, the canopy rangehood should be disconnected from the main power supply. Ensure that the rangehood is switched off at the wall socket and the plug removed. • External surfaces are susceptible to scratches and abrasions, so please follow the cleaning instructions to ensure the best possible result is achieved without damage.
accessories Optional ducting accessories wrg970cs* WRg980cgs† NOTE: Accessories are to be purchased separately.
notes
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: WESTINGHOUSE CANOPY RANGEHOOD This document sets out the terms and conditions of product warranties for the Westinghouse canopy rangehood. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Westinghouse appliance. General Terms and Conditions 1.
305469400/0 for more information on all Westinghouse appliances, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 363 640 fax: 1800 350 067 email: customercare@electrolux.com.au web: www.westinghouse.com.au NEW ZEALAND phone: 09 573 2384 fax: 0800 363 600 email: customercare@electrolux.co.nz web: www.westinghouse.co.
