User manual
Check that the installation complies with standards of
local building, gas and electrical authorities. Before
connecting to the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate
inside the cooker hood.
When installing the cooker hood, make sure you adhere
to the minimum and maximum distances from the cooker
hood base to the hob surface (as per table on right hand
side) and as required by Australian Standards.
The following rules must be strictly followed to obtain
optimal air extraction.
• Keep exhaust duct short and straight
• Do not reduce the size or restrict exhaust duct.
• Keep bends in the exhaust duct to a minimum.
• When using exible duct always install duct with
helix pulled taut to minimise pressure loss.
• Failure to observe these basic instructions will
drastically reduce the performance and increase
the noise levels of the cooker hood.
Exhaust air must not be discharged into a wall cavity,
unless the cavity is designed for that purpose.
The exhaust from the cooker hood must not be
discharged into any heating flue, which may carry
combustion products from other sources
NOTE: Some installations may require the telescopic exhaust
cover to be cut to length. Cut with sharp tin snips or a
fine-tooth hack saw blade, taking care not to distort or dent
the exhaust cover.