User manual
Using a small flat blade screwdriver remove the inner
stainless steel ring to obtain access to the halogen
globe. When removing the inner ring, do so carefully,
as the glass lens could easily fall out of the inner ring.
Remove halogen globe, whilst cool, and replace
carefully with a new globe.
The rangehood takes 2 x 20W, 12 volt halogen globes.
When handling globes hold with a cloth or gloves to
ensure perspiration does not come in contact with the
globe as this can reduce the life of the globe.
• Before maintenance or cleaning is carried out,
the canopy rangehood should be disconnected from
the main power supply. Ensure that the rangehood is
switched off at the wall socket and the plug removed.
• External surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
Clean stainless steel surfaces using non-abrasive
cleaning products that are specifically for use on
stainless steel.
To ensure best results also use an even pressure and
follow the grain of the stainless steel. Use of a soft cloth
reduces the risk of scratching. If the cloth is wet ensure
that a dry soft cloth is used to wipe down the surface
again reducing the risk of any surface rust appearing.
The mesh filters can be cleaned either by hand or in
the dishwasher. After cleaning ensure that the filters are
completely dry before refitting.
By hand: Soak in warm water with some washing liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains.
In a dishwasher: Ensure that placement of the filters
is made so as to not impede the function of the spray
arm. Washing the filters in a dishwasher may cause
discolouration of the aluminium inner mesh over time
although it will not affect their performance. Filters should
be washed separately to crockery and kitchen utensils.
The glass fascia on model WRG980CGS can be
cleaned with window cleaner or a mild detergent and
hot water and paper towelling.