User Manual

6
OPERATION & MAINTENANCE
Maintenance
WARNING!
Do not change the light bulb or carry out maintance
immediately after use as the bulb and the cooker
hood maybe hot. Allow it to cool first.
Use both hands for removing and re-fitting the filter
and the front panel to avoid accidentally dropping
the filter or the front panel on to your cooktop or
kitchen bench.
0 1
0 1
2
IMPORTANT!
The Edison Screw lamps may have come loose during
transportation.
Ensure that lamps are tightened firmly into the socket
before power is applied.
Best result are obtained by using a low speed for normal
conditons and a high speed when odours are more
concentrated. Turn the hood on a few minutes before you
start cooking. It should be left on after cooking for about
15 minutes or untill all odours have disappeared.
Light switch: This switch is used to turn the light
fitted in the hood on and off.
Extractor fan switch:
Slide position 0:
Slide position 1:
Slide position 2:
Used to select fan speeds.
Fan off
Fan speed Low.
Fan speed High.
• Before maintenance or cleaning is carried out,
the rangehood should be disconnected from
the main power supply. Ensure that the rangehood
is switched
off at the wall socket and the plug
removed.
• External surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
• There is a fire risk if cleaning is not carried out
in accordance with the instructions.
•
•
1. Remove the filter, then unfasten the front panel fixing
screws then remove the front panel.
2. Replace with 5.5W maximum E14 LED candle lamp.
The lamp assembly includes a sillicone seal, this must be
replaced when a new lamp is used. The silicone seal is
placed over the lamp thread and then the lamp is screwed
into the holder. Ensure replacement lamp is tightened
firmly. Replacement lamps from Electrolux Parts Centres
are supplied with sillicone seals.
Cleaning steel surface
Clean
stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and
follow the grain of the stainless steel. Use of a soft cloth
reduces the risk of scratching. If the cloth is wet ensure
that a dry soft cloth is used to wipe down the surface
again reducing th
e risk of any surface rust appearing.
Cleaning grease filters
The mesh filters can be cleaned by hand in warm soapy
water. Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains. After cleaning ensure that the filters
are completely dry before refitting.
Replacing the lamp
Take care of sharp edges during installation,
maintenance and cleaning. When the filters,
light cover or fascia panel are removed,
wear gloves for protection.
•
E14 5.5W LED -> DBL-5.5-H-E14-35/102
Suitable lamp for replacement