User Manual

ARNING
ARNING
ARNING
INSTALLATION
11
INSTALLATION
Positioningthemachine
When considering the location for the dishwasher,
ensure that there is adequate space to enable loading
and unloading of the dishes.
• Do not put your machine in any location where the
ambient temperature can fall below
0
°C.
• Before positioning, take the machine out of its
packaging by following the warnings located on
the package.
• Position the machine close to a water tap and
drain. You need to position your machine, taking
into consideration that its connections will not be
altered once they are made.
• Do not grip the machine by its door or panel in
order to move it.
• Take care to leave a certain clearance from all sides
of the machine so that you can comfortably move
it back and forth during cleaning.
• Make sure that the water inlet and outlet hoses do
not get squeezed while positioning the machine.
Also, make sure that the machine does not stand
on the electrical cable. Adjust the machine’s feet
so that it is level and stable. Proper positioning of
the machine ensures problem-free opening and
closing of its door.
• If the door of your machine does not close properly,
check if the machine is stable on the oor; if not,
adjust the feet and ensure it is level and stable.
Waterconnection
Ensure that the indoor plumbing is suitable for installing
a dishwasher and complies with AS/NZS 3500.1. Also,
we recommend that you t a lter at the entrance of
your place or apartment so as to avoid any damage
to your machine because of any contamination
(sand, clay, rust etc) that might be
occasionally carried in through the
main’s water supply or the indoor
plumbing, and to avoid problems of
staining and formation of deposits
after washing.
Waterinlethose
Do not use the water inlet hose of
your old machine, you must use
the new water inlet hose supplied with your machine.
Before connecting the water inlet hose to the water
tap, ensure clean water is owing from the tap before
making the connection. Connect the water inlet hose
directly to the water inlet tap. The pressure supplied by
the tap should be at a minimum of 0.03 MPa and at a
maximum of 1 MPa. If the water pressure is above 1
MPa, a pressure-relief valve should be installed.
Onlyturnthelockingnuttosecurehose–
donotturnthehose.
• The rst time you use the appliance, make sure
that there is no leakage.
• The water inlet hose has a safety valve and a
sheath with an inner mains cable.
• After the connections are made, the tap should be
turned on fully and checked for water tightness.
For the safety of your machine, make sure to
always turn o the water inlet tap after each wash
program is nished.
NOTE: A water tempering valve is required if the water
temperature is over 60°C.
C AUTION
Alwaysusenewhoseswhenyouconnectthe
appliancetothewatersupply.Oldhosesmust
notbeused.Thewaterinlethosemustbe
examinedatanintervaloftwelvemonthsfor
deteriorationandreplacedifnecessary.
Inordertopassthesafetyvalvethroughthe
kitchencabinets,anopeningofatleast45mmx
90mmisneeded.
30cm
min.
WARNING
WARNING