User Manual
LOADING YOUR DISHWASHER
16
LOADING YOUR DISHWASHER
If your dishes are correctly placed in the dishwasher,
you will be using it in the best way in terms of energy
consumption, washing and drying performance.
There are two separate baskets for you to load your
dishes into your machine. You can load into the lower
basket such round and deep items as pots with long
handles, pot lids, plates, salad plates, cutlery sets.
The upper basket has been designed for tea plates,
dessert plates, salad bowls, cups and glasses. When
placing long-stem glasses and goblets, lean them against
the basket edge, rack or glass supporter wire and not
against other items. Do not lean long glasses against
one another or they wont remain steady and can be
damaged.
It is recommended that thin narrow items be placed into
the middle sections of baskets. You can place spoons
among the other cutlery sets in order to prevent them
from sticking to one another, use the cutlery grid in order
to obtain the best result.
To avoid any possible injuries, always place long-handle
and sharp-pointed dishes such as serving fork or bread
knife with their sharp points facing down or horizontally
on the baskets.
CAUTION
Place your dishes into your machine in a way that they
will not prevent the upper and lower spray arms from
spinning.
Top basket cup rack
Height Adjustable Rack
These racks are designed to increase the capacity of the
top basket. You can place your glasses and cups on the
racks. You can adjust the height of these racks. Thanks to
this feature, you can place different sizes of glasses under
these racks.
Thanks to height adjustment plastics mounted on the
basket, you can use your racks in two different heights.
In addition, you can place long forks, knives and spoons
on these racks laterally
, so that they do not block the
revolution of propeller.
Upperbasketheightadjustmentwhileitisfull
Basket height adjustment mechanism on the upper
basket of your machine is designed to let you adjust the
height of your upper basket (refer to diagram 1) upwards
or (refer to diagram 2) downwards, without removing it
from your machine when it is full, to create large spaces
at the upper or bottom area of your machine as needed.
The basket of your machine is set to the upper position
from the factory.
In order to raise your basket, hold it from both sides
and pull it upwards. In order to lower it, hold it from both
sides again, pull upwards and then lower carefully.
Make sure that both sides are in the same position (up or
down).
1 2