User Manual

ManualsBrandsWestinghouse ManualsDishwashersFreestanding Dishwasher

TIPS & INFORMATION

MAINTENANCE AND CLEANING

IMPORTANT

Cleaning the machine in regular intervals prolongs the

machine’s service life.

Oil and lime may accumulate in the machine’s

washing section. In case of such accumulation;

• Fill the detergent compartment without loading

any dishes into the machine, select a program that

runs at high temperature, and start the machine. If

this is ineffective, use a specialty dishwasher cleaner

available from most supermarkets.

Cleaning the seals in the machine door

• To clean any accumulated residues in the door seals,

wipe the seals regularly by using a dampened cloth.

Cleaning the machine

• Clean the filters and spray arms at least once a week.

• Unplug your machine and turn off its tap before

starting the cleaning.

• Do not use hard materials when cleaning your

machine. Wipe with a fine cleaning material and a

dampened cloth.

Filters

• Check if any food wastes have remained on the

coarse and fine filters.

• If any food wastes are left, remove the filters and

clean them thoroughly under the water tap.

Micro Filter

Coarse Filter

Metal/Plastic Filter

To remove and clean the filter combination, turn it counter

clockwise and take it out by lifting upwards.

Pull and remove the metal/plastic filter.

Then pull the coarse filter out of the micro filter.

Rinse it with lots of water under the tap. Refit the

metal/plastic filter. Insert the coarse filter into the micro

filter in away that the marks will correspond to one

another. Attach micro filter into the metal/plastic filter

and turn to the direction of arrow and it is locked when

the arrow on micro filter can be seen from across.

• Never use your dishwasher without any filter.

• Incorrect fitting of the filter will reduce the washing

effectiveness.

• Clean filters are very important in terms of the proper

running of the machine.

Spray arms

Check whether or not the holes for the upper and lower

spray arms are clogged. If there is any clogging, remove

the spray arms and clean them under water.

You can remove the lower spray arm by pulling it

upwards, while the upper spray arm nut can be removed

by turning the nut to the left.

Be sure that the nut is perfectly tightened when refitting

the upper spray arm.

Hose filter

Water is stopped by the inlet hose filter to avoid any

damage to your machine because of any contamination

(sand, clay, rust etc.) that might be occasionally carried in

through the mains water supply or the indoor plumbing,

and to forestall such issues as yellowing and formation

of deposits after washing. Check the filter and the hose

from time to time and clean them if necessary. To clean

the filter, first turn off your tap and then remove the hose.

After removing the filter from the hose, clean it under the

tap. Insert the cleaned filter back into its place inside the

hose. Refit the hose.