User Manual

10 11INSTALLING THE MACHINEINSTALLING THE MACHINE
INSTALLING THE MACHINE
towards the rear and lift it.
4 Adjust the machine feet according to the slope
of the floor.
5 Fit your machine by pushing it undercounter
without letting the hoses get crushed or bent.
WARNING
WARNING
After removal of worktop, ensure the opening for the
dishwasher is according to the following dimensions.
min. 600mm
820mm
570mm
INSTALLATION INSTALLATION
Water drain hose
The water drain hose can be
connected either directly to
the water drain hole or to
the sink outlet spigot. Using
a hose hook (if available),
the water can be drained
directly into the sink by
positioning the hose hook
over the edge of the sink.
This connection should be at a minimum of 50cm and at
a maximum of 110cm above the base of the dishwasher.
WARNING
WARNING
Maximum drain hose length is 4m. Longer hose length
will prevent correct draining, and result in poor wash
performance.
INSTALLING THE MACHINE
WARNING
WARNING
Electrical Connection
The plug of your machine should be connected to an
earthed outlet that supplies suitable voltage and current. If
there is no earthing installation, have a competent electrician
carry out an earthing installation. In case of usage without
earthing installed, our company will not be responsible for
any loss of usage that might occur.
The indoor fuse current value should be 10-16 A.
Your machine is designed for 220-240 V. The machine
should not be plugged in during installation.
• Always use the molded plug supplied with your machine.
• Running in low voltage will cause a decline in
washing quality.
• The machine’s electrical cable should be replaced by
an authorised service or an authorised electrician only.
Failure to do so may lead to accidents.
• For safety purposes, always make sure to disconnect
the plug when a wash program is finished.
• In order not to cause an electric shock, do not unplug
when your hands are wet.
• When disconnecting your machine from the mains supply,
always pull from the plug. Never pull the cord itself.
Fitting the machine undercounter
If you wish to fit your machine undercounter, check whether
you have sufficient space under your countertop and
whether the wiring-plumbing is suitable to do so.
1 To ensure the stability of the dishwasher for an
underbench installation, if the underbench dimension is
greater than 820mm, any gap between the dishwasher
and the underside of the benchtop should be bridged
with a packing piece. This may be achieved by wedging
a piece of timber between the dishwasher and the
benchtop as shown
2 If required, remove the worktop as shown in the
illustration.
3 To remove the worktop, remove the screws that hold
the worktop which are located at the rear of the
machine; then push the front panel 1 cm from the front
570
465
97
85
598
598
850 820
Timber
wedging
piece
Bench top
3mm gap
Filler piece
cut to suit
installation
Floor level
1 2
3
4
5