User Manual

TROUBLESHOOTING
TROUBLESHOOTING
21
Errorcode Possiblecauseandsolution Control
F1
Overll
• Power o your machine and close the tap.
• Contact the customers services centre.
F2
Not draining
• Water discharge hose is clogged.
• Water drainage hose kinked, check installation.
• The lters of your machine might be clogged.
• Power o–on your machine and activate the program
cancellation command.
• I f the error continues, contact the Customer Care Centre.
F3
Inlet valve faulty
• Close the tap.
• Contact the Customer Care Centre.
F5
Pressure system failure
• Contact for service.
F6
Faulty heater sensor • Contact the Customer Care Centre.
F7
Over temperature • Contact the Customer Care Centre.
F8
Heating error • Contact the Customer Care Centre.
F9
Diverter valve faulty • Contact the Customer Care Centre.
FE
Power supply problem • Contact the Customer Care Centre.
EnA
Electronic Card
Comminication Failure
••
FF
Water inlet system failure
• Make sure the water inlet tap is open and
water is flowing.
• Separate the inlet hose from the tap and
clean the filter of the hose.
• Contact for service if the error continues.
Turn machine Off and then On. If the
error persists contact the Customer
Care Centre.