User Manual

34 35CARE AND CLEANING CARE AND CLEANING
Cleaning the door glass panels
WARNING
CAUTION
Do not to use harsh abrasives on the glass panes as the
reflective surface plays a role in the function of the oven.
Do not place glass in dishwasher. Hand wash only with a
soft cloth and warm soapy water. When dry polish with a
soft cloth and ensure the glass is dry before reassembly.
Re-assembling the quad glazed oven door
(on selected models)
Re-assembling the door glass panels
• Assemble the silicone spacers to the upper corners
of one of the clear glass panels. Position the panel
into the lower position of the door, ensuring the
chamfered corner of the panel is placed in the correct
location as shown in the image below.
Chamfer to be located in this corner
Silicone spacers
• Insert the remaining smaller clear glass panel into the
middle position, ensuring the chamfered corner of the
panel is placed in the correct location as shown in the
image below.
• Lay the oven door with the outer side facing
downwards on something soft and flat (for example a
blanket on a kitchen table) to prevent scratches.
Removing oven door top trim
• Hold the embossed sections of the door columns
at each end and press inwards to release the clips.
Remove the upper door trim by pulling it
towards you.
Removing the door glass panels
WARNING
CAUTION
Rough handling, especially around the edges can cause
the glass to break.
• Lift the black bordered glass panel out of the
guide and place on something soft and flat to
prevent scratches.
• Repeat this for the smaller clear glass panels.
• When removing panel 3, ensure that the two rubber
spacers are removed before cleaning.
Do not misplace them!
CARE AND CLEANING (CONTINUED)
Fitting the oven door
• Take hold of the oven door with a hand on each side
and with the door at an angle of 30˚, position the
recesses at the bottom of the door onto the hinge
arms of the oven. Let the door slide down the hinge
arms as far as it will go.
• Open the door fully to access the hinges.
• Rotate the ‘stirrups’ (see the image below) until
they lock into the hook. The oven door may now
be closed.
stirrup in locked
position
door
column
Cleaning the side open door (on selected models)
Side open door models have been designed to allow for
the inner glass panels to be removed for cleaning.
Removing side open door top trim
Take hold of the grid embossed sections of the door trim
at each end and press inwards to release the clips. Then
remove the door trim by lifting it upwards.
Chamfer to be located in this corner
• Insert the black bordered glass panel into the upper
position, ensuring the painted surface is facing the
downside as per the image below.
Replacing the top door trim
• Hold the top door trim at each side and position it to
the inside edge of the glass.
• Push the trim down with its top edge over the glass
panel until the clip snap in on each side of the trim.
• Push the middle of the trim down to ensure it is
straight and firm against the glass panel.