User Manual

ASSEMBLY INSTRUCTION

E296-05 SOFA TABLE TV STAND

A B C D

Allen Wrench

4MM

Top Panel

2PCS 24PCS 1PC

1PC 1PC 1PC 3PCS

Shelf

Cross Bar

Side Frame

Bottom Panel

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place

the contents on a carpeted or padded area to

protect them from damage.

2SETS

Anti-Tipping HW

Bolt

1/4”*3/4”

PAGE 1
ASSEMBLY INSTRUCTION E296-05 SOFA TABLE TV STAND A Top Panel B 1PC E Cross Bar 2PCS C Bottom Panel 1PC F Shelf D 1PC G Bolt 1/4”*3/4” 24PCS Allen Wrench 4MM 1PC Side Frame 3PCS H Anti-Tipping HW 2SETS This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
***Do not tighten screws & bolts until the entire unit is completely assembled. 1 Assembly the Top Panel (A) and Bottom Panel (B) onto the Side Frame (D), then using the Bolt (F) by Allen Wrench (G). D A D A F G B D G D F D B 2 Assembly the Shelf (C) onto the Side Frame (D) and using the Bolt (F) by Allen Wrench (G).
PAGE 3
Assembly the Cross Bar (E) onto the Side Frame (D) and using the Bolt (F) by Allen Wrench (G).
PAGE 4
*NOTE: WE RECOMMEND THAT YOU ATTACH THE PRODUCT TO YOUR WALL AS A SAFETY PRECAUTION USING ANTI-TIPPING HW (H) AS BELOW INSTRUCTION. Attach Mounting Plate to the Top Panel (A) by using Wood Screw, make sure the Mounting Plate extend DOWNWARD. Drill 2 holes in your wall approximately 2” (Inches) BELOW the corresponding positions of Mounting Plate and insert Wall Anchor as shown. *NOTE: You may need to tap LIGHTLY with a rubber mallet.