User Manual

WING
AILERONS
Each aileron has four hinge points pre-cut. Carefully insert the mylar hinges supplied in
the accessory pack into the ailerons ensuring that the long cut-out in the centre of the
mylar hinge runs parallel to the leading edge of the aileron.
Once in place lock these into position with a couple of drops of thin cyano top and
bottom. Ensure the pre-cut slits in the wing align with the mylar hinges in the aileron.
When you are happy insert the aileron into the wing so there are no gaps between the
wing and the aileron and there is no binding at the edge. Push the aileron down and apply
thin cyano to the hinges. Repeat procedure on the opposite side of the same aileron.
Repeat procedure on the other aileron.
AILERON SERVOS
Install a small draw wire through the wing section very carefully ensuring you do not
catch any ribs and draw the servo cable through the wing section to the exit point at the
centre of the wing. Repeat procedure for the other servo. Secure servos in place with the
servo arm forwardmost, take the two aileron pushrods supplied and attach the clevises to
the threaded ends. With your servo in the neutral position clip the pushrod onto the servo
arm. You can now use this to align the position of your aileron control horns on the
aileron over the strengthening points. Once the position has been found, ensuring the
clevis attachment point on the horn is positioned over the hinge line, secure into position
by drilling and bolting the control horn and backing plate together. Repeat procedure on
the other aileron. Disconnect the aileron pushrod clevis from the servo and connect to the
control horn. With the servo in the neutral position and the aileron in the neutral position,
connect the control rod into the servo arm using the swing keeper. Repeat procedure on
the other rod.