User Manual

TAIL PLANE
Position the tail plane on the fuselage ensuring that it is correctly aligned. When happy
mark out the joining points with a pen and remove the tail plane. Using a very sharp knife
remove the film ensuring that you do not cut into the wood. When happy glue the tail
plane to the fuselage with epoxy.
FIN
Insert the fin into the pre-drilled hole in the back of the fuselage and ensure it passes
through the fuselage and into its pre-drilled locator in the bottom of the fuselage. If this is
not correctly inserted into the fuselage the fin post will not be at the correct angle and
when the rudder is attached it may bind against the tail plane. Once in position mark out
the fin post point on the fuselage. Remove the film with a sharp knife making sure not to
cut into the wood. Reassemble the fin into the fuselage and glue into position. It is
advisable to run some glue down at the back of the fuselage internally to secure the
carbon rod into the lower part of the fuselage. Insert the mylar hinges into the rudder pre
cut slits as per the ailerons. Insert the rudder into the post and ensure there is no binding
on the tail plane. When happy secure into position with thin cyano.