User Manual

TAIL SKID
Fit the tail skid 20mm from the rear of the
fuselage using the 3 x 8mm self tapping screws.
Using the ply plate and triangle re-inforcing install the speed
control tray. Use the speed control to set how high the tray
can be as you need it to be as high as possible for the lipo
access. With the tray in position you can now mark out and
cut the holes for the cooling ducts. Make sure the two side
ones are below the speed control tray hight. Cut and glue
the cooling ducts into position and install the speed controller.
Run a smooth thin film of 5min epoxy along the bottom of the
fuselage and when dry attach some velcro to the bottom of
the fuselage for the attaching of the lipo.