Use and Care Guide

-5--16-
1. Place the Base (red) on a stable surface (Figure 9).
2. Insert the Herb Blade labeled “HERB-B” (with
the wording facing up) into the Base, turn so that
Blade snaps down onto the lowest notches in the
Base (Figure 10).
3. Insert the second Herb Blade labeled “HERB-T”
(with the wording facing up) on top of the bottom
Herb Blade (Figure 11).
4. Align the grooves on the bottom of the Container
(clear) with the notches in the newly assembled
Base. Twist the Locking Ring until the groove and
notch click into place (Figure 12).
5. Line up the square end of the Spring Loaded
Pusher with the square opening of the Handle, push
it in until it is fully seated (Figure 13).
6. Line up the slot of the Spring Loaded Pusher
with the dividers of the Container. Insert the Spring
Loaded Pusher into the Container (Figure 14).
7. Push the Handle down so that the Spring Loaded
Pusher is fully seated inside the Container. Twist
the Handle clockwise until the Container clicks
locked (Figure 15).
8. The Herb Grinder is ready to use. Follow the
“USING THE GRATER-GRINDING HERBS and
GARLIC” instructions in this book.
HERB GRINDER ASSEMBLY
Figure 9
Figure 10
Base
Herb-B Blade
Notches in Base
Herb-B Blade
Base
Figure 11
Herb -T Blade
Base / Blade Assembly,
Upright Position
Figure 12
Container
Base / Blades
Assembly
Figure 13
Handle
Spring Loaded
Pusher
Figure 14
Handle / Spring
Loaded Pusher
Assembly
Container
/ Base Assembly
Figure 15
NETTOYAGE ET RANGEMENT
Figure 22
Base
Base de rangement
des lames
Lames HERB-B,
HERB-T, GARLIC-B et
GARLIC-T
1. Démontez l’unité en prenant soin de séparer tous
les composants.
2. Le nettoyage doit être effectué immédiatement
après avoir utilisé le produit pour éviter que les
aliments ne sèchent sur les pièces. La râpe peut être
lavée à la main dans de l’eau chaude savonneuse.
Ne jamais utiliser de produits abrasifs ni de tampons
pour nettoyer les composants.
3. La râpe peut être lavée en le plaçant sur le
panier supérieur du lave-vaisselle. Positionnez
soigneusement les lames pour qu’elles ne puissent
pas couper ni endommager les ustensiles.
4. Séchez bien la râpe.
5. Assemblez l’unité en procédant selon les
instructions ASSEMBLAGE - RÂPE À FROMAGE/
COUPE-FROMAGE.
6. Placez les lames Herb-B, HERB-T, GARLIC-B
et GARLIC-T dans la base de rangement des lames
(Figure 22).
7. Alignez les crans de la base de rangement des
lames aux rainures de la base. Enclenchez la base
de rangement des lames dans la base.
8. Placez la râpe dans sa boîte d’origine dans un
endroit frais et sec.