Use and Care Guide

ENGLISH INSTRUCTIONS
9
CLEANING
GRINDER ASSEMBLY
1. Remove the Front Ring Nut, Grinding Plate,
Knife and Auger from the Grinder Head
before installing the Grinder Head to the
Main Body.
2. Align the notches on the Grinder Head with
the tabs on the Main body.
3. Insert the Grinder Head into the Main Body
and push the lever up to lock into position
(FIGURE B).
4. Insert the Auger into the Grinder Head,
Auger Driver end rst (FIGURE C).
5. Place the Stainless Steel Grinder Knife onto
the square portion of the Auger Pin. The
cutting edges (at side) of the Knife should
be facing out (FIGURE D).
6. Place the Grinding Plate of your choice onto
the Auger Pin. Make sure the positioning
pins of the Grinding Plate t into the notches
on the Grinder Head (FIGURE C).
7. Turn the Front Ring Nut clockwise onto the
threaded end of the Grinder Head until it
touches the Grinder Plate and is snug. DO
NOT over-tighten.
8. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder
without the Tray installed!
FIGURE B
FIGURE C
FIGURE D
Auger
Pin
Cutting edges of the Knife facing out.
ENTANGLEMENT HAZARD: Disconnect power before
cleaning, disassembling or assembling.
!
WARNING