User Manual

ManualsBrandsWeston ManualsFood MillsCast Iron Food Mill

REV010813

MANUAL

GRAIN & CORN

MILL

MODEL # 36-3601-W

Due to constant factory improvements, the product pictured

might differ slightly from the product received.

ATTENTION!

If any components of this unit are broken, do not operate properly, or for product returns,

please contact Weston Products LLC

Phone: 1-800-814-4895 (Outside the U.S. 440-638-3131)

Mail: 20365 Progress Drive, Strongsville, Ohio 44149

E-Mail: CustomerService@WestonProducts.com

Web Site: WestonProducts.com

All Trademarks and Registered Trademarks are property of the respective companies.

SAVE THESE INSTRUCTIONS!

Refer to them often and use them to instruct others.

Summary of content (4 pages)

PAGE 1
ATTENTION! All Trademarks and Registered Trademarks are property of the respective companies. SAVE THESE INSTRUCTIONS! Refer to them often and use them to instruct others. MANUAL GRAIN & CORN MILL MODEL # 36-3601-W Due to constant factory improvements, the product pictured might differ slightly from the product received. REV010813 If any components of this unit are broken, do not operate properly, or for product returns, please contact Weston Products LLC Phone: 1-800-814-4895 (Outside the U.S.
PAGE 2
6 1d 5 WESTON WARRANTY INFORMATION 3 SAVE THIS WARRANTY INFORMATION FOR YOUR RECORDS! 1a 1b 1c 4 1d 2b 2c 2a Main Body 6 3 5 Foot Clamp Thumbscrew COMPONENT LIST DIAGRAM NUMBER 1 2 3 4 5 6 PART DESCRIPTION Shield Assembly 1a Grinding Plate Pressure Screw 1b Wing Nut 1c Shield 1d Rotating Thumbscrew with Bolt (2) Auger Assembly 2a Auger 2b Adjustable Grinding Plate 2c Retainer Cap Protector Pad Hopper Handle Thumbscrew with Cap Washer PART NUMBER 36-3604 CUT ALON
PAGE 3
GRINDING INSTRUCTIONS GENERAL SAFETY RULES Figure F 1 Fill the Hopper with the material you intend to grind. 2. Position a bowl or plate under the Mill to catch the material as it is being ground (Figure F). WARNING! 3. Slowly turn the Handle clockwise. 1. KEEP FINGERS CLEAR of the Auger and Grinding Plate at all times. NEVER reach into any Mill inlet. ADJUSTING THE GRIND 2. KEEP CHILDREN AWAY. NEVER LEAVE THE MILL UNATTENDED.
PAGE 4
IMPORTANT NOTE PRIOR TO USE! A protective coating is applied to this unit prior to shipment. This coating protects the unit in shipment and during it’s shelf life. It is very important to thoroughly clean the unit before using it, especially around the edges or areas that have been soldered or welded. Completely disassemble and thoroughly clean all parts with hot water, dish detergent and a soft cloth. Rinse with clean water and dry thoroughly.