W westwood design Assembly Instructions Donnington Convertible Crib
Congratulations on your purchase of a Westwood Design product. We take great pride in the quality and design of our furniture. The safety of your child is our highest priority. It is important that you read these instructions carefully and completely to ensure that this product functions as it was designed. After opening the package, check to see that all the parts are present. If you think something is missing, please contact your retailer, and they can arrange to have the missing parts quickly replaced.
Hardware: K Allen Wrench Were you expecting more hardware? This crib uses Westwood's ground-breaking Always There HardwareTM system- the hardware is permanently contained inside the crib, so it is easier to assemble, there is no hardware to misplace if you put the crib into storage, and no chance of using the wrong bolt in the wrong location.
Step 1 A. Align the Headboard (A) with the crib sides. The spring mounting holes on the crib sides must face the inside of the crib B. Thread the bolts into the fittings on the headboard and tighten with the allen wrench. Repeat for the other side.
Step 2 A. Thread the screws on the Mattress Support (F) into the attachment holes on the crib sides and tighten with the allen wrech. There are three possible height settings. The support should be at its highest setting for newborns, then adjusted to the lower positions as the child grows and becomes mobile. Once the child is able to stand, the support should be at its lowest position.
Step 3 A. Place the Footboard (B) against the front of the crib. B. Thread the four bolts into the footboard fittings, but don’t tighten them all the way yet. Repeat for the other side. C. Once all the bolts are threaded, tighten them with the allen wrench.
Day Bed Conversion A. Undo the four bolts attaching the upper footboard to the sides and remove the upper footboard. There are two bolts on each side. B. If it's not already, adjust the spring to its lowest position, following the procedure shown in these instructions. C. Place the Right Day Bed Cap (J) against the right crib side (the extra two threaded inserts on the side should face the inside of the crib as shown), thread the three bolts into the fittings on the cap, and tighten with the allen wrench.
Care and Maintenance ! After completing assembly, check that all bolts and screws are secure and tight. Hardware can become loose over time, so it is your responsibility to periodically check the tightness of all fasteners for as long as you use the crib. ! Wood is a natural material. As such, it can be affected by changes in temperature and humidity.