W westwood design Assembly Instructions Meadowdale Crib Guard Rail
! WARNING FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. < READ ALL INSTRUCTIONS BEFORE ASSEMBLING CRIB. KEEP INSTRUCTIONS FOR FUTURE USE. < PREVENT BURNS. KEEP BED AWAY FROM OPEN FIRES AND OTHER HEAT SOURCES. < ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27-1/4 IN. (69 CM.) BY 51-5/8 IN. (131 CM.), WITH A THICKNESS NOT EXCEEDING 6 IN. (15 CM.). THE DIMENSIONS OF THE MATTRESS SHOULD BE TAKEN FROM SEAM TO SEAM.
Step 1 A. Using the allen wrench,remove the six bolts attaching the footboard to the crib and remove the footboard. B. Unscrew the removable feet from the bottom of the footboard and save them for the next step.
Step 2 A. Screw the removable feet from the footboard into the bottom of the crib sides. B. Adjust the spring to its lowest position,following the procedure shown in these instructions. C. Use the bolts you removed from the footboard (O) to attach the guard rail to the crib. Tighten securely using the allen wrench. D. Insert the allen bolt (P) through the top hole in the corner post,and thread it into the cap nut (Q) as shown. Tighten securely using the allen wrench. Repeat for the other side.
Mattress Height Adjustment The toddler bed can only be used with the mattress support in its lowest position. To adjust the mattress height,follow these steps: A. Carefully ti p the crib onto its back. B. Undo the four wing nuts holding the support arms to the spring and remove the screws. C. Lower the spring to the desired setting and align the holes. D. Insert the screws and tighten the wing nuts. Wing Nut Support Arm Lowest Middle Highest W westwood design 635 N. Billy Mitchell Rd., Ste.