westwood design Assembly Instructions Newcastle Cottage Crib Toddler Guard Rail
! < WARNING FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. READ ALL INSTRUCTIONS BEFORE ASSEMBLING CRIB. KEEP INSTRUCTIONS FOR FUTURE USE. < PREVENT BURNS. KEEP BED AWAY FROM OPEN FIRES AND OTHER HEAT SOURCES. < ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27-1/4 IN. (69 CM.) BY 51-5/8 IN. (131 CM.), WITH A THICKNESS NOT EXCEEDING 6 IN. (15 CM.). THE DIMENSIONS OF THE MATTRESS SHOULD BE TAKEN FROM SEAM TO SEAM.
Step 1 A. Undo the six bolts attaching the crib side to the crib ends and remove the crib side. B. If it's not already, adjust the spring to its lowest position, following the procedure shown in the crib instructions.
Step 2 A. Align the Toddler Guard Rail with the crib ends. B. Thread the three bolts you removed in the last step into the fittings on the ends and tighten with the allen wrench. Repeat for the other side. Required Hardware 6 x Allen Bolt, 2-1/8” Long Allen Wrench Thread and tighten all three bolts (both sides) Toddler Guard Rail westwood design 635 N. Billy Mitchell Rd., Ste.