How to Guide

APPLICATION TIPS
Weekly Application: After showering, spray Wet & Forget Shower on fixtures, shower curtains, enclosures,
shower glass, tiles and tubs. Then simply rinse surfaces before or during your next shower.
Starting with a Dirty Shower: If you’re starting with an extremely dirty shower, no problem! Wet & Forget
Shower goes to work on contact eliminating soap scum, grime, oils, mold and mildew stains. Simply apply Wet
& Forget Shower after the last shower of the day and let it sit until the next day. Rinse the shower and, if
necessary, give it a quick wipe-down. If there are still signs of shower grime, repeat the same routine until
clean. No scrubbing required! Once you achieve a clean shower, you’ll only need to apply Wet & Forget
Shower one time per week to maintain a clean, fresh shower.
Tough-to-Reach Areas: Wet & Forget Shower is equipped with a remote-spray trigger that allows you to
pivot the trigger into any position to get to those tough-to-reach areas. Go ahead turn the sprayer upside-down
— you’ll get the same product flow that you’d get in the upright position. The Wet & Forget Shower spray
trigger has the ability to spray up to 10 feet allowing you to clean those not so easy-to-reach areas.
Where to Use: We always recommend testing Wet & Forget Shower in an inconspicuous area prior to using.
Enclosures: Showers, Shower Glass.
Fixtures: Brass, Chrome, Bronze, Stainless, Nickel.
Shower Curtains: Vinyl, Rubber, Nylon, Plastic.
Tiles: Ceramic, Porcelain, Mosaic, Slate, Granite.
Showers & Tubs: Acrylic, Porcelain, Fiberglass, Granite, Slate, Glass Tiles, Natural Stone.
Sinks & Toilets*: Acrylic, Porcelain, Granite.
* Require a wipe down before next use. Wet & Forget Shower is not recommended for use on natural
marble. Test in an inconspicuous area if you have dark tiles and hard water to avoid highlighting calcium
deposits.