~Tff%EJ{bft[J:{} A 5 5£Fll £5
THAN~ YOU FOR PURCHASING WET SOUNDS! Congratulations! Thank You for purchasing the Wet Sounds ST-AS6/ ST-ASl 0 Stealth series powered subwoofer system. Wet Sounds professional marine audio products represent the ultimate in high performance marine audio. Wet Sounds products are specifically engineered to withstand the rigorous marine environment.
INSTALLATION INSTRUCTIONS IMPORTANT! BEFORE MAKING ANY CONNECTIONS, DISCONNECT THE BATTERY POWER UNTIL THE INSTALLATION IS COMPLETED TO AVOID POSSIBLE DAMAGE TO THE ELECTRICAL SYSTEM. INSTALLATION Mounting Find the proper spot in your vehicle to mount the subwoofer enclosure. The enclosure should be mounted securely to a flat surface using the supplied hardware. For the ST-ASIO, the mounting holes are integrated into the enclosure.
INSTALLATION I REMOTE LEVEL CONTROL Route the Blue Remote Turn On Wire (4) to a location where it can connect to the Remote Turn On Output from the source unit. If using the latest Wet Sounds Stealth Sound Bar, this will be a blue wire. On a traditional head unit, this wire is often labeled "power antenna remote". It should be a wire that supplies + 12V when the source unit is powered on and returns to OV when the source unit is powered off.
AMPLIFIER ADJUSTMENTS AMPLIFIER ADJUSTMENTS FOR THE ST SERIES SUBS wet s o u nd s ~ ~©~========~©~==========©~ ~ = G) ............. ~ --~-""""""J=~=~~~~ 0 ... 0 121a x.oA GAff 0 G) G) ,., .a ,., flAX © 1 - AUTO TURN ON SWITCH The "REM" Setting is the most reliable way to turn the ST series subwoofer on and off, but if the source unit does not have a Remote Output wire then either the "AUDIO" or "DC OFFSET" setting can be used.
AMPLIFIER ADJUSTMENTS (CONTINUED) "AUDIO" Setting senses a music signal to turn on the amplifier built in to the ST series subwoofer. This setting is recommended for earlier model Wet Sounds Stealth Sound Bars. Please note- if the source unit is powered ON, but at "0" volume, the ST series subwoofer will likely not turn on until the volume is increased. 2- The Gain Adjustment controls the sensitivity of the amplifier built in to the ST series subwoofer.
ADJUSTMENTS I SPECIFICA TIDNS ADJUSTING THE X-OVER. BASS BOOST AND PHASE 3- The Variable Crossover Network allows adjustment of the frequency range that the amplifier sends to the subwoofer. This should be adjusted to fall slightly above the lowest frequency that the full range speaker/s in the system can reproduce. 4- The Variable Bass Boost allows the selection of the amount of bass boost- centered at 45Hz- that is desired in the system. There is no specified setting for this.
AIJJUSTMENTS I SPECIFICATIONS ADJUSTING THE X-OVER. BASS BOOST AND PHASE 3 -The Variable Crossover Network allows adjustment of the frequency range that the amplifier sends to the subwoofer. This should be adjusted to fall slightly above the lowest frequency that the full range speaker/s in the system can reproduce. 4- The Variable Bass Boost allows the selection of the amount of bass boost- centered at 45Hz - that is desired in the system. There is no specified setting for this.
LIMITED WARRANTY What This Warranty Covers This is a "limited" warranty. This warranty covers any defect in materials and workmanship. This warranty only covers the original purchaser and is not transferable. This warranty is also only valid if the original purchase was made from an authorized Wet Sounds™ dealer. How long Coverage lasts This warranty extends for 2 years from the date of purchase. It is recommended to REGISTER your warranty online within 45 days of purchase at www.wetsounds.
LIMITED WARRANTY longer available. Labor costs and materials needed to complete this service will be at No Charge to the purchaser. Additionally, return shipping FROM Wet Sounds, Inc. to the purchaser will be paid for by Wet Sounds. How To Get Service Contact Wet Sounds, Inc. either by phone (877-938-7757) or by email (warranty@wetsounds.com).
wet sounds WET SOUNDS INC. www.wetsounds.
STEALTH AS-6 BREAK-IN PROCEDURE As with any High Performance small enclosure subwoofer, the driver used in the Wet Sounds STEALTH AS-6 will benefit greatly from a proper break-in period. It is recommended that the AS-6 be played at moderate volume levels using normal music material for 6-8 hours before high-output demands are placed on the product. Proper break in will result in better sound, and longer life for the driver used in the AS-6. If you have any questions, please feel free to contact us at www.
