User Manual

Co-Developed with Wet Sounds the “Zone
Controller” allows individual or simultaneous
control of four separate lighting zones on your
boat or RV. Quickly change color and brightness
or set the lights to dance to music.
Supports Shadow-Caster’s “Shadow-Net” devices.
This allows communication with Shadow-Caster’s
line of under water and above water lights, along
with standard RGB Color Changing lights.
The backlit housing installs in a 3” gauge opening
and includes a wiring harness and mounting
hardware.
Zone button backlighting will allow each button to
match the selected color and mode of that zone
Zone Controller Operation Guide
Shadow-caster LED Lighting
www.shadow-caster.com
REV A 9/8/2012
Turn controller on
• Press ALL
Turn controller off
• Hold OFF for 2 secs
Initiate lighting
1) After controller has been turned on by pressing
ALL, press ALL again and all lights will return to
previous setting.
2) Press ALL, or press the desired zone number
then press desired color for full brightness
3) Press and hold a color and lights will fade up
from black and stop when button is released
4) Press Color then < or > to shift color hue
5) Press SYNC to activate music sync
• Press < , >, , to affect the music
sync intensity and color pallets
6) Press MODE to activate color changing / fade
modes
• Press one time for single color
fade/strobe
• Press two times for multicolor
fade/strobe
• Press < , >, , to affect the mode
intensity and color pallets
Dimming
• Press ALL, or press the desired zone number
then press or hold or
Turn zones off
• Press ALL, or press the desired zone number
then press OFF
<
<
<
<
<
<