Installation & Assembly

A 32 ea
Sleeve
D 4 ea
Upper pole
E 4 ea
Lower pole
B 4 ea
Foot
C 4 ea
Shelf
Tools Needed:
No tools required.
STEP 1. Connect upper pole (D) to lower pole (E) by
threading connector (F) into open end of the poles (there is
a small ridge in the middle of part (F) to gauge the
distance). Screw foot (B) into assembled pole at small
threaded end. Repeat step 1 for remaining poles.
STEP 2. Starting at the bottom (the
end with the small threaded hole, see
diagram above), snap two sleeves (A)
onto poles at desired intervals. The
sleeves are marked with a
directional arrow to show proper
placement. Use grooves on poles to
ensure even shelf placement among
the four poles. NOTE: Place only
enough sleeves to assemble bottom
shelf. This step will be repeated for
each additional shelf.
STEP 3. Slide poles
with plastic cap on top
through shelf corners
until shelf rests firmly on
sleeves. Push or gently
tap the shelf down at
corners to level shelf.
Repeat steps 2 and 3 for
each additional shelf.
Turn feet (B) to level unit.
NOTE: part D has a plastic cap on one end.
NOTE: part E has a small threaded hole on one end.
E
D
D F
D
D E
E
A
B
Assembly
Time:
Less than
30 minutes.
F 4 ea
Threaded connector
(may be already attached to D or E)
This product's intended
use is for storage in all
environments in a home or
commercial setting. The
shelf capacity is 350 lbs.
when weight is evenly
distributed.
4 Tier Shelving
Printed in China
NEED HELP? For help with assembly, or if you are missing a part,
please call our Customer Service Department
TEN YEAR LIMITED WARRANTY
All our wire products distributed by the Company are warranted to the original purchaser at the time of purchase and for ten (10) years after the purchase date ("warranty term"). The Company warrants to you, the original
purchaser, that our wire products and all metal or plastic parts and components are free of defects in material or workmanship during the warranty term .The word "defects" as used in this limited warranty is defined as any
imperfections which impair the use of the wire product. This limited warranty is expressly limited to the replacement or repair of metal or plastic parts and components (in the Company's discretion) and the Company will have a
reasonable amount of time to remedy said defect. This limited warranty only applies under conditions of normal use. This limited warranty does not cover defects caused by improper assembly or disassembly, defects occurring
after purchase due to intentional damage, product modifications, exposure to the elements (including, but not limited to, wet environments), accidents, misuse, abuse or negligence and labor or assembly costs.
THE COMPANY DISCLAIMS ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, EXCEPT TO THE EXTENT
THAT ANY WARRANTIES IMPLIED BY LAW CANNOT BE VALIDLY WAIVED. NO ORAL OR WRITTEN INFORMATION OR ADVICE GIVEN BY THE COMPANY, ITS DISTRIBUTORS, DEALERS, AGENTS OR EMPLOYEES, SHALL CREATE ANOTHER
WARRANTY OR MODIFY THIS LIMITED WARRANTY. THIS LIMITED WARRANTY STATES THE COMPANY'S ENTIRE LIABILITY AND YOUR EXCLUSIVE REMEDY AGAINST THE COMPANY FOR ANY FAILURE OF THE WIRE PRODUCT TO
OPERATE PROPERLY. NEITHER THE COMPANY NOR ANYONE ELSE INVOLVED IN THE DEVELOPMENT, PRODUCTION, OR DELIVERY OF THIS WIRE PRODUCT SHALL BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL,
CONSEQUENTIAL, EXEMPLARY, OR PUNITIVE DAMAGES, INCLUDING LOST PROFITS, ARISING FROM THE USE OF OR INABILITY TO USE THE PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO
NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. This Warranty gives you specific legal rights and you may also
have other rights, which vary from State to State.
The Limited Warranty set forth above is provided on products purchased in and used in the United States, and is only in effect with valid proof of purchase (bill of sale) presented or shipped (shipping cost prepaid) to the Company
within the United States.