Installation & Assembly

Overview: The retaining portion of all Wall Control Slotted Tool Board hooks and attachments
offer a unique “double offset” design. This design prevents the attachments from
unintentionally falling out of the panel, yet still permits easy movement from slot to slot.
Please note that for 1/4” Pegboard Accessories conventional engagement will still apply for
the round holes. Simply place the pegs in the round holes and you’re done.
For
Application Images
be sure to Follow
The required motion for Slotted Hook Engagement is shown below. A simple “Up, down, up,
down” motion is all that is required to engage a slotted hook or accessory.
Step 1: Slip the upper portion of the rear tang through the slot
in the panel in an upward motion as illustrated here
Step 2: Rotate the body of the tang into the slot and lower the
hook so the rotation arc in the tang rests on the panel
Step 3: Lift the hook and rotate the lower end of the hook
toward the slot on the panel face
Step 4: Lower the hook until the positioning slot in tang is fully
seated in the panel’s slot
Hook Engagement
Installation & Assembly