User's Manual

Page: 6
3. First mount the antenna holders 3 to 4’ above the ground (two holders for every
side) , and scew the passive antennas into the doorframe.
4. Plug the antenna connections onto the system and do the same to Tx loop
connection.
5. The power line connections are ready with the system when out of box, but if
expansion of the power line is needed, the termination can be connected as the
above diagram shows. The left terminal is for power line grounding, and the right
terminal is for power line N and L terminations. N and L can be swapped.
6. Finally when all the connections ready, mount the housing onto the system and fix it
by screwing down the screws at the upper and lower side of the system housing.