User's Manual

58KHz Mono-Guard Transceiver System Quick Start
To avoid explosion, do not operate this equipment in an explosive
atmosphere unless it has been specifically certified for such operation.
Have qualified personnel perform safety checks after any completed
service.
Risk of electric shock is present. A grounded circuit conductor
(neutral) is provided with over current protection. Test all components
before touching.
Cautions
To prevent damage to equipment when replacing fuses, locate and
correct the trouble that caused the fuse to blow before applying power.
Verify that all power supply lights are off before removing the power
supply or servicing equipment.
Use only specified replacement parts.
Leave the base of the system clear for air exhaust cooling and to allow
room for cabling. Slots and openings in the system are provided for
ventilation. Do not block them.
To prevent damage to this equipment read the instructions in this
document for proper input voltage range selection.
Circuit boards in this equipment are densely populated with surface
mount and ASIC components. Special tools and techniques are required
to safely and effectively troubleshoot and repair modules that use SMT
or ASIC components. For this reason, service and repair of products
incorporating surface mount technology are supported only on a module
exchange basis. Customers should not attempt to troubleshoot or repair
modules that contain SMT components. It assumes no liability
for damage caused by unauthorized repairs. This applies to both in- and out-
of-warranty products.
Introduction
Congratulations on your purchase of one of the finest EAS systems on
the market. This is the Installation Instructions manual.