User Manual

Premier Guard Installation Manual

Connecting the Pedestal

Before the connecting the transceiver, place it at the location where you intend to install it,

and arrange the cables directly from the PLCU to the transceiver.

1. Remove the base cover of the pedestal to expose the transmitter board (picture below).

Note: Press down the top of base cover towards pedestal and LIFT the half case upward to

release the cover from the pedestal’s locking mechanism.

2. Loosen the screws to remove the cable wires from the connector. Feed the cable through

the slot of the aluminum base mounting plate, and then reconnect the cable wires to the

connector according to wire connection table.

3. Plug the three connectors (Power, Tx Signal and Rx Signal) onto the appropriate sockets

on the transmitter board (see picture below).

4. After completing all connections, firmly mount the pedestal base to the ground. (See

following page.)

5. Re-install the base cover.

From

Transformer

Box

Removing The Base

Use a screwdriver to punch

the cover at the hole. The

cover lock will release, and

then you can take apart the

two halves.

Power Sockets

(3 Pins)

Control Signal

Sockets (3 Pins)

RX Signal

Sockets

(

2 Pins

)

From PLCU

Either of the two

pedestal sockets

Clockwise

– increase sensitivity

– prone to false alarms

Counter-Clockwise

– decrease sensitivity

– less false alarms

Rx signal pre-process sensitivity

From PLCU