User Manual

Premier Guard Installation Manual
26
Note: Inputting the wrong password will cause an error message to be displayed as
per the following picture. After three successive times of inputting an incorrect
password, the remote will be disabled. You will need to turn system power off/on and
input the password again.
When the correct password is verified, the panel will display the following and is now ready for
receiving configuration inputs.
There are three basic steps to inputting a programming parameter:
• Press function button.
• Input parameter number.
• Press [CON] to accept the parameter.
After parameter confirmation, the panel will display the tag window signal. If there is no tag in
the detection zone, the value reflects the noise level in the receiving window without a tag.
The upper value reflects the signal level in the tag window from antenna channel 1. The lower
value reflects the signal level in the tag window from antenna channel 2. (See NSE noise
display entry; it’s the same value with D1)
CH 1
CH 2
0 E rr
-
94
- 13