Information

- 10 -
3 LCD
Be careful when soldering
the LCD connections.
Overheating will damage
the LCD screen.
II. ASSEMBLY
1. Roughen the 4 bolts with a knife, a le or some abrasive paper so it will be easier to solder them to the front panel.
2. Assemble the unit but do not yet tighten the bolts (g.1).
3. Position the unit onto the rear of the front panel with the display is centred in the cut-away.
Temporarily x the unit to the rear using non-permanent tape (g. 2
Assembly
Display module
Position the unit onto the rear of the front panel with the display is centred in the cut-away.
Assemble the unit but do not yet tighten the bolts (g.1).
Position the unit onto the rear of the front panel with the display is centred in the cut-away.
Assemble the unit but do not yet tighten the bolts (g.1).
Position the unit onto the rear of the front panel with the display is centred in the cut-away.
Assemble the unit but do not yet tighten the bolts (g.1).
Assemble the unit but do not yet tighten the bolts (g.1).
Position the unit onto the rear of the front panel with the display is centred in the cut-away.
Temporarily x the unit to the rear using non-permanent tape (g. 2
Temporarily x the unit to the rear using non-permanent tape (g. 2
Temporarily x the unit to the rear using non-permanent tape (g. 2
��������������������������� ��������������������