Instructions

13
The included demo software makes it easy to experiment.
Start by selecting the address : tick off SK5 and/or SK6 (see
address selection).
ATTENTION : Execute these settings before connecting the
kit with the computer or before booting the computer.
 Connect the USB cable.
 LED LD3 'Power' lights up if the connection has been exe-
cuted properly.
 After startup LD4 (output 4) will flash momentarily to indicate
that the circuit works as it should.
 Start the program 'K8055_Demo.exe'.
Next press the 'connect' button to connect the K8055 with the
computer.
The message "Card x connected" is displayed if the connection
is successful, see fig 3.0.
Test procedure
21 Test procedure
SK5 SK6 ADDRESS
ON ON 0
OFF ON 1
ON OFF 2
OFF OFF 3
FIG 3.0